E031002C 10/04/09
18
EFFECT POSSIBLE
CAUSE
The ironer do not dry enough: the garments come
out still wet
Check if:
−
Electric heated ironer: the heating switch on
the back left side is on
−
Steam heated machine: the steam supply is
open
−
The ironing speed is too much high referring
to the linen residual humidity
−
The drying temperature is too much low
−
The humid air exhaust is obstructed: in this
case the air depressor transducer is not
allowing the flame control device start (only
for gas heated ironers)
−
The cooling function was wrongly selected
Call the authorized service centre.
The ironed linen come out yellow
Check if:
−
The ironing temperature is too much high
and the drying is excessive
−
The ironing speed is too much low referring
to the linen residual humidity
−
The linen was not well rinced and some
detergent stay on the clothes: the PH must
be between 5 and 6.
−
The linen is introduced on all the ironing
length, so that there are no roller surface
with a different temperature
Call the authorized service centre.
The ironed linen come out with dark stain
Check if:
−
The ironing surface used is bigger than one
allowed: the only ironing surface usable is
the one delimitate from the introduction
belts.
The ironed linen come out deformed
Check if:
−
The linen is correctly introduced: the linen
must be introduce side by side with the hand
safe bar
Call the authorized service centre.
When START is pressed, the ironer starts but stops
immediately and the display shows “OFF”
Check if:
- the “MOTOR OVERHEATING” or “GAS
PRESSURE” alarms were displayed with a
temperature below 80°C
Call the authorized service centre.
The machine works properly, without alarms, but the
heating system doesn’t start.
Check if:
- the max temperature probe intervened: make a
manual reset;
- if the ironer is gas heated, check the humid air
exhaust. If evacuation is not enough the flame
control stops.
Call the authorized service centre.
