E031002C 10/04/09
13
16.
WORKING: SAFETY DEVICES CONTROL
After the machine is switch on, before to start to work, it is compulsory to control the safety device perfect
working. Each time the machine is switch on, the user must follow the here below procedure.
ACTION
REACTION
Press the key ON/OFF
The roller MUST start to turn.
Press the key ON/OFF
→
The roller MUST stop.
Start the roller rotation and lift the hand safe
bar protection.
Repeat the same operation at least on three
points of the hand safe bar: in the middle, at 50
cm from the right side and from the left side.
→
In each one of the three tests, the roller must
stop: the RESET red button must light on.
Start the roller rotation: Press the right
emergency push button.
→
The roller must stop: the RESET red button
must light on.
Start the roller rotation: Press the left
emergency push button
→
The roller must stop: the RESET red button
must light on.
Once the safety device check has been done, you can start to iron.
ATTENTION! Each user must be informed about the above procedure and konws how the
safety devices work.
17. IRONING
Switch on the machine bringing the main switch in position “ON”, as per instruction given in the previous
paragraph.
Before to start the machine always check the safety devices correct working (check the relative paragraph).
When the machine is switch on the software version and release date are displayed for a while.
Later the display shows:
Control that all the safety device are not in use:
-
If the emergency push buttons are pressed, please turn them clockwise.
-
If the side doors are open, close them
-
Control if the hand safe bar is free to work correctly.
-
Control that the RESET red button, on the right side, is on.
-
Press the RESET button: the red light is off and you can start to iron
OFF
M1.16
01/01/09
