E031002C 10/04/09
11
Point 1: door to access to the ironer electric board. This door can be open using the plastic key supplied with
the machine documentation. The access to the electric board must be allowed only to specialised and
competent personnel.
Point 2: the main switch. When it is in position I, the machine is electrically supplied.
Point 3: microprocessor.
Point 4: emergency stop buttons. They must be pressed when the ironer rapid stop is necessary.
Point 5: hand safe bar. When it is pressed, the machine stops.
13. WORKING
CYCLE
While working the entire roller length must be used, in order to maintain the same temperature on all the
roller length.
The machine dried and iron only flat linen.
Ironing temperature must comply with the temperature written on the fabric label.
Residual humidity on the linen that must be ironed, cannot be above the 50%. It means that this ironer must
be used with linen washed in a high spin washing machine.
Hourly production written on the technical data sheet has been calculated on the base of ISO 9398
standards.
ATTENTION! Yellow stains on ironed linen means that the detergent was not well rinsed!
ATTENTION! Wrinkles on the ironed linen may means a to much low residual humidity.
Please pay attention also to the fabric thickness. Differences in the thickness of the same
cloth may origin wrinkles. Ironing of a folded cloth may origin wrinkles.
Ironing double or folded linen may cause wrinkles.
ATTENTION! Do not start to iron until the minimum temperature of 80°C has been reached
and, anyway, do not start to iron before the minimum ironing temperature adequate for the
linen to work has been reached.
ATTENTION! In case of emergency and necessity of a rapid machine stop, push one of the
two emergency push buttons on the machine sides. Once the emergency button is pushed,
the ironing roller.
ATTENTION! When the emergency stop button is pushed, the roller stop. If the temperature
is above 80°C, the ironing belts may burn. In case the machine could not be starter again,
pass a wet bed sheet between roller and belts making roll the roller manually as described in
the relative paragraph. This operation needs to be repeated until the temperature goes under
80°C.
ATTENTION! The ironing surfaced is defined by the ironing and introduction belts. Ironing out
of the introduction belts may stain the clothes.
