FLOYD User Manual rev 1.09
www.diamondsystems.com
Page
39
Install Jetson Module
1. If not present on board, install 2 M2.5 x 6.5mm long spacers along board edge. If heat sink will be
installed, also install 2 spacers next to module connector. See illustration.
2. Insert module into socket at 45 degree angle. See illustration.
3. Push down module so that both side latches click fully into position. You may need to push down on the
module PCB and push in the latches because it is a tight fit. See illustration.
4. If heat sink will not be used, insert 2 M2.5 x 10mm long screws through module into spacers. See
illustration above.
Always needed
Needed with
heat sink
Always needed
Needed with
heat sink
Install screw
Install screw