FLOYD User Manual rev 1.09
www.diamondsystems.com
Page
34
Flashing Jetson Nano Module
1. Download the BSP Image file
DSC-Floyd-Nano-release-2.0-20201016.tar.gz
, from the FTP site
and copy it to a directory on the Linux Host Machine.
Alternatively, the file may be copied to a different source such as the Desktop.
2. Issue the following command to navigate to the directory containing the downloaded file:
cd
~/Desktop
To unzip the copied Image file:
3. Issue the following command depicted below.
sudo
tar
‐
pxvzf
DSC
‐
Floyd
‐
Nano
‐
release
‐
2.0
‐
20201016.tar.gzx
It may take a few minutes for the file to unzip.
NOTE
: The
tar.gz
file name is liable to change according to the version and release date.
To switch to the directory where the file has been extracted:
4. Issue the following command as depicted below.
cd
Linux_for_Tegra
To flash the Jetson Nano Module:
5. Issue the following command as depicted below.
sudo
./flash.sh
jetson
‐
nano
‐
emmc
mmcblk0p1
NOTE
: Do not interrupt or interfere with the USB connectivity or the power supply to the carrier board until
the flashing procedure is complete.
The flashing process will take 15-20 minutes to complete.
The system will automatically Reboot when the flashing process is complete.
6. Switch off the module and remove the recovery mode USB cable connection.
