MAINTENANCE
WARNING
If the DPF soot level reaches Regen Level 4
(Red) due to inhibiting regeneration, the
engine should be shutdown and a qualified
engine or OEM service technician will be
required to perform a forced regeneration.
1. To conduct a parked regeneration of the
DPF the following conditions must be met:
•
Machine is in a safe area with the
speed control lever in the
STOP/PARK
position
•
Engine is in low idle
•
Regen setting must in set to “Uninhibit
Regen”
•
If ambient temperature is at or below
50° F> (10° C), ensure the canvas
radiator cover is installed in accordance
with the “Cold Weather Parked
Regeneration” procedure called out
earlier in this manual
2. Once these conditions are met, go to the
Menu screen and choose “Utilities”
3. From the Utilities menu select “Regen
Settings”
4. From the “Regen” menu select “Request
Regen”
5. A series of three blue pop-up messages
will appear on the control screen:
Regeneration, Screen 1
Regeneration, Screen 2
Regeneration, Screen 3
6. Use the UP/DOWN arrows to maneuver
through the screens until the “Request
Regen” soft key appears.
7. Select “Request Regen” to begin the
regeneration process.
NOTE: During the regeneration process, the
engine speed will increase and there may be
noticeable sound difference.
CAUTION
DO NOT attempt to operate the unit, change
engine RPM or move from “Parked/Stop”
while regeneration is occurring. This will
abort the regeneration process and require
to start the process over.
CAUTION
Once the process has started it can be
stopped by selecting the “Stop Regen” soft
key. DO NOT shutdown unless it is
absolutely necessary. Continue to monitor
the surrounding areas during the process. If
unsafe conditions develop, shutdown the
unit immediately.
The regeneration process will take
approximately 20-30 minutes to complete. The
following green pop-up message will appear on
the control screen when the process is
completed:
Regeneration Complete
When this message appears, the machine can
return to normal operation.
63