Diamond Products CORE CUT CC110-SS, Operator'S Manual

Page: 9 / 40

CC110-SS and CC110D-DC Concrete Saw Manual 5
Introducing the CC110-SS and CC110D-DC
Controls
Figure 1: CC110-SS/CC110D-DC Controls
1. Fuel Tank Cap –Fuel port; indicates fuel level.
2. Speed Control Lever –Forward/neutral/reverse
control for the saw.
3. Hex Key –Use to tighten the inner flange screws
when installing/removing blades (CC110D-DC
only).
4. Wrench –Use to tighten the blade shaft bolt
when installing/removing blades.
5. Stop Engine Light –Indicates an engine
problem. The engine must be stopped
immediately for maintenance.
6. Wait to Start Light –Indicates when to start the
engine if using a glow plug (applicable models).
Note: The engine
will turn off within a short time if not done
manually.
7. Check Engine Light –Indicates an engine
problem. The engine must be stopped as soon
as possible for maintenance.
8. Water in Fuel Light –Indicates that water must
be emptied from the water/fuel separator.
9. AUX Switch –Raises or lowers fifth wheel
(CC110D-DC only).
10. Ignition Switch –Starts the engine.
11. CANtrak Generic Engine Monitor (GEM) –
Displays engine data and alerts, and records
additional information when operating the saw.
Note: Refer to the GEM manual for information
on using the monitor
12. Vernier Throttle –Increases or decreases the
engine rpm.
.
Item(s) not shown above:
1. Emergency Stop Button –Stops the engine.
2. Control Grip –Pushbuttons raise or lower the
saw and blade.
3. Spotlight Switch (Optional) –Turns the
spotlight on or off.
1
4
3
2
9
11
12
10
8
6
5
7