Diamond Products CORE CUT CC110-SS, Operator'S Manual

Page: 20 / 40

16
•
Turn off all electricity, gas, and water around the
direct work area prior to cutting.
Making a Cut
1. Align the blade and guide with the cutting line.
2. Turn on the water valve and adjust the water flow.
3. Slowly lower the blade into the concrete surface and
make a two-inch deep pass across the entire cutting
line as the guide cut. DO NOT cut to the entire depth
in one pass.
4. Raise the blade out of the cut and reposition the saw
at the end of the cut. DO NOT move backwards in a
cut.
5. Starting at the end of the cut, lower the blade back
into the cut and make a deeper pass across the
entire cutting line again, using the most efficient rpm
speed and traveling speed.
Note: Always use the
step-cut method when cutting for maximum
efficiency. For example, when cutting to a depth of
ten inches, begin with a two-inch deep pass, then a
four-inch deep pass, and finish with another four-
inch deep pass to complete the cut
6. Raise the blade out of the cut and reposition the saw
at the end of the cut as necessary. Continue the
step-cut process to reach the maximum depth. DO
NOT cut any deeper than required.
.
Continuing a Partial-Cut
1. Maneuver the saw to the desired location.
2. Align the blade with the previous cut and slowly
lower the blade back into the concrete. Use extreme
caution to make sure the blade is perfectly aligned
within the cut. DO NOT continue cutting until the
blade is aligned within the cut!
3. Continue the step-cut process to reach the
maximum depth.
Finishing a Cut
1. Place the speed control lever at neutral.
2. Raise the blade from the cut (provide proper ground
clearance).
3. Turn off the water.