Diamond Products CORE CUT CC110-SS, Operator'S Manual

Page: 17 / 40

CC110-SS and CC110D-DC Concrete Saw Manual 13
9. Align and fit the outer flange through the blade and
into the blade shaft. Note: The outer flange should fit
snug with the blade, inner flange, and blade shaft
10. Slightly rotate the outer flange and blade backward
to eliminate backlash (looseness) between parts.
.
11. Place the washer onto the blade shaft bolt and insert
the bolt into the blade shaft through the center of the
outer flange.
12. Tighten the bolt by hand, and then tighten the bolt
again, using the wrench, to 125 ft-lb (169.5Nm) to
secure the outer flange and blade. Verify this
measurement with a torque wrench.
13. To ensure safety, have a second trained operator
carefully lift the front of the guard and realign the
front and back of the blade guard.
14. Replace the pivot bolt to secure the entire guard
together.
15. Raise the blade out of the pre-existing cut (with the
engine off!) .
Removing the Blade
CAUTION
•
DO NOT remove a blade with the
engine running.
•
DO NOT pivot the front of the blade guard up
or down when removing large blades.
Attempting to pivot the front of the guard when
the guard is raised higher up for blade removal
makes the guard very heavy and difficult to lift
and/or lower.
Note: If desired when removing large blades, lower the
blade into the finished cut (with the engine off!) to
lower the position of the flanges, blade, and blade guard,
making the process a little easier when handling
larger/heavier components
.
1. To ensure safety, have a second trained operator
hold the front of the blade guard in place. Remove
the pivot bolt securing the front and back of the
guard together, and remove the front of the guard
from the saw.
2. Slowly lower the blade, if necessary, until it just
touches the ground.
3. Remove the blade shaft bolt using the wrench.
4.
CC110-SS:
5.
Carefully remove the outer flange from
the blade and inner flange. Remove the blade and
place in an appropriate storage location.
CC110D-DC:
6.
Carefully remove the outer flange from
the blade shaft.
CC110D-DC:
inside finished cut) and place in an appropriate
storage location.
Remove the six blade screws from the
blade and inner flange. Remove the blade (slowly if
7. Inspect the flange assembly and clean or replace
dirty/damaged components.
8. CC110D-DC:
9. Carefully fit the outer flange back into the inner
flange and/or blade shaft.
Retighten the blade screws to the
inner flange.
10. Place the washer onto the blade shaft bolt and insert
the bolt into the blade shaft through the center of the
outer flange.
11. Tighten the bolt to secure the blade flanges.
12. To ensure safety, have a second trained operator
carefully lift the front of the guard and realign the
front and back of the blade guard.
13. Replace the pivot bolt to secure the entire guard
together.
Engine
WARNING
•
Operate the saw in well-ventilated
areas. Concentrated engine exhaust
can cause loss of consciousness
and/or death.
•
DO NOT touch the engine/muffler with the
engine running, and always let them cool down
prior to touching or servicing the saw.
•
DO NOT leave the saw unattended while the
engine is running.
Vernier Throttle
Figure 9: Vernier Throttle
1. Turn the
Hold/Release
2. Turn the throttle clockwise to increase the engine
rpm or counterclockwise to decrease the engine
rpm.
knob counterclockwise to
loosen the knob.
Note: The engine must run at half throttle or