OPERATING THE ALL AMERICAN DISC
DISCING
CONTINUED ON NEXT PAGE
Use to reclaim road shoulder material.
•
Start the tractor and raise the engine RPM’s to operating speed.
•
Extend the optional swing cylinder (if present) until the disc housing
(1)
is
at full extension
(2)
.
•
Use the pitch cylinder to adjust the pitch
(3)
of the cutting discs.
◦
The pitch of the cutting discs should allow the rearmost disc to enter
the soil before the lead disc when the discs are lowered into the soil.
◦
DO NOT
exceed a maximum of 15° difference in height between the
rearmost and lead cutting disc.
•
Lower the cutting discs into the ground, but do not exceed 1” (25mm)
cut depth.
◦
DO NOT
cut sod with the lead blade! This indicates either there is
not enough pitch or the cutting depth is too deep, and will result
in peeling large clumps of sod; this is undesireable. Cutting is
accomplished with the other blades.
-
Adjust your pitch as needed to prevent cutting with the lead disc.
(2)
(1)
(3)
12
Summary of Contents for ALL AMERICAN DISC
