Diamond H2O DCS6-120-125, Product Manual

Page: 6 / 25

Patriot Series Single Tank Product Manual
pg. 5
4. Connect the brine tank.
A. Remove the ties on the brine line hose (included in the brine tank).
B. Remove the well cap and connect one end of the brine line hose to
the brine line connection (Shown in Figure 12) of the brine tank.
Tighten the brine line hose to the brine line connection by turning
the cap of the brine line connection clockwise by hand. Make sure
that no air can get into the line, or the softener will not regenerate
properly.
C. A red latch with a Polytube insert attached is placed under the brine inlet of each valve. Place
this insert in the brine line before connecting it to the brine inlet. (Figure 14)
Tighten all connections using a wrench and tightening the caps clockwise.
D. Safely dispose of any leftover tubing.
E. Fill the brine tank with salt.
Figure 12: Brine Tank
Diagram
Figure 11: Brine Well Picture
Brine Line Connection
Well Cap
Figure 14: Control Valve Diagram
Brine Inlet
Drain Outlet
Valve Inlet
Valve Outlet
Figure 13: Installing Brine Line Polytube