Diamond H2O DCS6-120-125, Product Manual

Page: 10 / 25

Patriot Series Single Tank Product Manual
pg. 9
8. Program the Valve
To enter into the programming mode, press and hold the indicated buttons on the control valve for 5 seconds. For each set of
settings (A-H), the display will start by showing the parameter listed as a. To go to the next parameter, press the next button on the
control valve. To go back to the last parameter, press the regen button on the control valve. After you hit next on the last parameter,
you will be returned to the home screen, where the clock should be displayed.
Important: All OEM softener setup settings will be entered by Diamond H2O prior to shipping. No value in these settings
needs to be changed in the field. If you can’t get into a certain setting, make sure the display is unlocked (Part D).
B. OEM Softener Setup Settings (Entered by Diamond H2O)
Press and Hold:
NEXT
&
a. Type of water treatment device ( Softening /Filtering)
Softening: This device is a water softener
Filtering: This device is a filter
b. Capacity of Resin (in grains per gallon of hardness)
Default: 25,000gpg
Note: This value is dependent upon the volume of resin used and will be set by Diamond H2O.
c. Amount of Salt per Regeneration (pounds)
Default: 10.0lbs
Note: This value is dependent upon the volume of resin used and will be set by Diamond H2O.
d. Backwash length ( NORMAL /LONGER)
Normal: The system will backwash for the preset amount of time.
Longer: The system will backwash for longer than the preset amount of time.
e. Set Volume Capacity (Gallons)
AUTO: (default) The volume capacity will be estimated by the hardness entered in installer settings.
Off: Regeneration is based on day override.
Number of Gallons (20 to 50,000): Number of gallons that will flow through the valve before regeneration.
The volume capacity can be determined using the volume capacity chart on pages 14 and 15.