Diamond Engineering PC-9042-NS, Installation And Configuration Manual

Page: 12 / 29

12
PC-9042 Portable Anechoic Chamber Installation & Configuration
Installation
1. Mount the controller base in the desired location, utilizing the four screw holes
which are sized for either #10 wood screws or M6 flathead machine screw.
2. A good location is either on the bottom of the chamber or the rear wall behind the
positioner. Drill four separate 3/32” pilot holes, approximately 15mm in depth.
IMPORTANT : Do not drill into absorber!
3. If desired, tape included template (shown below) to the outside of the chamber.
Be sure your desired installation location is within reach of the cables. Also be sure
connectors are facing the cables.
4. Using the included screws, fasten the controller mount to the chamber with the
“back” towards the control cables.
5. Now you can slide the controller all the way onto the mount. You will feel two
clicks once it’s fully locked into place.
Mounting The Controller Base
(for self-install units only)
BA
CK
Controller Base Plate Template