Dialogic
®
DSI SPCI Network Interface Boards Programmer's Manual Issue 5
13
Net start Septel
After rebooting the interface will be displayed as expected.
4)
Right click on the "Septel" driver and select "Properties" and then select
the "Driver" tab.
5)
The driver can be started immediately by selecting "start" in the "current
status" field.
Note:
To automatically start the driver at system startup, select the "Automatic" option
from the "Startup" menu. The system must be re-started for this change to take
effect. It is strongly recommended that automatic startup be NOT enabled until
the correct operation has first been verified using manual startup.
On some systems, when using DSI SPCI Boards, the device driver does not
get registered. It may be necessary to manually start the driver using the
command "net start septel".
3.3.3
Clearing Windows
®
2000 Install Wizard
The Windows
®
2000 system may fail to fully recognize that the board is
controlled by the driver. It may consequently produce an "Install Wizard"
window for each board that is present at system boot.
This "Install Wizard" window may be quit without any problems; however, the
user may choose to use this work around to prevent the "Install Wizard"
window being presented, thereby removing the need for manual intervention:
1)
Select the Control Panel (Start
Æ
Settings
Æ
Control Panel).
2)
Select the "System" icon. In the "system properties" select the
"Hardware" tab and then select "Device manager". A tree of device nodes
is presented.
3)
Open the "Other Devices" branch. One "Network Controller" is listed for
each installed SS7 board.
Note:
Additional Network Controllers may be listed for other non-WDM
boards in the system, in which case the user must identify which belongs to
each resource.
4)
"Disable" and then "enable" each of these "Network Controller". This is
achieved by right clicking on the device.
5)
Reboot the system.
The "Install Wizard" window will no longer be presented for the device.
