Dhollandia DH-RP.10, Installation Manual

Page: 64 / 76

63
DHOLLANDIA
Figure 19.3
19.5 2-BUTTON PORTABLE CONTROL

The optional 2-button handheld control [1 in Figure 19.4] with spiral cable is supplied with a plug premounted on the spiral cable
[4 in Figure 19.4], and a socket [5 in Figure 19.4] that is installed during the installation of the tail lift.

Mount the socket [5] in the top corner of the vertical body panel, or other position where it is protected against physical damage.
[Figure 19.4]

Mount the socket [5] vertically to minimize the impact of accidental water ingress. [Figure 19.5]

Route the cable [6] of the socket to the pump unit and connect it according to the wiring diagram supplied with the tail lift.

Make sure the cable [6] is protected against physical damage. Run the cable inside the rear post of the vehicle body or mount a
steel protection plate over it.

If the tail lift is equipped with a main external control box (with compulsory 2-hand control), other than the toggle-switch described
in this manual, wire the power feed of the 2-button portable control into the safety button of that control box in conformance with
the wiring diagrams.

Mount the holder [2] for the handheld control [1] in a position that is as much as possible protected against physical damage, and
within reach of the operator. The handheld control [1] is also equipped with a magnet, so that it will stick to any metal surface.

Mark the safe operator position on the platform and mount a hand grip to the rear frame of the vehicle body in conformance with
Appendix 4.
400mm
250mm
400mm