32
DHOLLANDIA
8.6
OPERATION OF THE PORTABLE RAMP DH-AI02
Position the ramp vertically with the 2 handles
facing upwards. The opposite side of the platform
is equipped with wear pads to avoid scratches of
the platform as much as possible.
Release the platform lock and separate the two
platform halves.
Flip the ramp over to its work position.
Place the ramp inside the vehicle and let it rest on
the rubbers or the fixation bolts.
Make sure and verify before each passage that the
ramp is properly rested on the vehicle floor and
cannot slide or fall out during operation.
Make sure the ramp is fully aligned at both ends:
the inboard platform edge with the vehicle floor and
the outboard edge with the ground. Make sure the
4 corners are in firm contact with a hard surface
(not floating).
8.7
ADJUSTMENTS
In case of problems with the alignment of the platform or the set-up of certain parts, consult the INSTALLATION MANUAL.
Contact your national DHOLLANDIA distributor when in doubt and before making any permanent changes. See contact details on
page 3.
