DFSK Seres 3 2019, User Manual, Page: 91 / 233

Instrument and Control Switch
- 90 -
To use washer, upwardly pull the
integrated switch of wiper until that
the required amount of washing liquid
comes from windscreen. Then, the
wiper will automatically work for
several times.
Rear Wiper and Washer
Switch
When the brake is stepped down and
the motor start-stop button is set at
“ON”, turn the integrated switch of
wiper handle at “ON” gear, the rear
wiper motor starts working; when you
set the ignition switch of wiper handle
at “ ”, the wiper motor and
washer motor will work together.
If the wiper suspends working due to
snow or ice, the wiper will not work to
protect motor. In case of such
circumstance, set the rear wiper at
“OFF”, remove the snow or ice on and
around the wiper arm, and turn on the
wiper again.
Automatic Wiper Function
Activated
Under normal power supply, when the
signal changes from "OFF" to "ON",
the automatic wiper function is
activated, and the wiper runs at a low
speed for one time.
When the brake is stepped down and
the motor start-stop button is set at
“ON”, the automatic wiper function is
activated. If there is water vapor on
the windscreen (nominal quantity), the
automatic wiper command is given;
and if there is no water vapor (the
nominal quantity), the automatic wiper
command is not given.
After power on, if the rain sensor fault
is detected, the fault signal should be
sent no matter whether the "AUTO"
switch is effective or not. After the
automatic wiper function is activated,
and the rain sensor has no fault, please
keep using the automatic wiper control
mode.
ON/OFF: cruise switch
CANCELC: cruise canceled
HEADWAY: memory cruise
RES+: cruising speed +
RES-: cruising speed -