DFSK Seres 3 2019, User Manual, Page: 84 / 233

Instrument and Control Switch
- 83 -
system works abnormally, and it needs
repairing. Please seek for repairing and
treating the power steering system from
the service stations authorized by DFSK.
If the power steering system indicator is on
during motor running, the power steering
system is invalid, but you can still control
your car. Now, you have to operate the
steering wheel with a greater force,
especially in case of a sharp turn and
driving at a low speed. (Refer to “Electric
Power Steering (EPS) System” in “6.
Starting and Driving”)
Abnormal tire pressure indicator
When the pressure of tire is abnormal or
the sensor is invalid, the indicator is on or
flashes, and the corresponding letters on
LCD flashes.
During driving, when the abnormal tire
pressure indicator is on, quickly park your
car as far as possible. If finding that the
tire leaks air or becomes flat quickly,
please refer to “Flat Tire” instructions in
Chapter 7 or seek for inspection from the
service stations authorized by DFSK.
EPB fault indicator
When EPB system is faulted, the EPB
system is under dangerous condition.
Please do slow down to park and contact
the service stations authorized by DFSK at
once for inspection. (Refer to “Parking
Brake” in “IV. Inspection and Adjustment
before Driving”)
High beam indicator
When the high beam light is on, the
indicator is on. When the low beam light is
on, the indicator is off. (See “Switch of
Headlight and Turn Signal Light”
hereinafter)
Rear fog lamp
When the rear fog light is on, the indicator
is on. (See “Fog Light Switch” hereinafter)
Turn signal / danger indicator
When turn the switch of turn signal light
or press alarm switch, the indicator flashes.
(See “Switch of Headlight and Turn Signal
Light” or “Danger Indicator Switch”
hereinafter)
Side marker light / position
indicator
When you turn on the side marker light,
the indicator is on. When you turn off the
side marker light, the indicator is off.
System failure indicator
It is on when the signal state is "Fault",
and off when the signal state is "No Fault".