www.dfi.com
22
Chapter 3 BIOS Setup
Chapter 3
22
Chapter 3 BIOS Setup
www.dfi.com
ACPI Configuration
This section is used to configure the system ACPI parameters.
Determines the action tak-
en when the system power
is off and a PCI Power
Management Enable wake
up event occurs.
ACPI Configuration
Wake on LAN <Disabled>
After G3 <Always>
BGRT Logo <Enabled>
Wake On RTC <Enabled>
Wake up time [00:00:00]
Advanced
F1
Help
↑/↓
Select Item
F5/F6
Change Values
F9
Setup Defaults
Esc
Exit
←/→
Select Item
Enter
Select
SubMenu
F10
Save and Exit
InsydeH2O Setup Utility
Rev. 5.0
Wake on LAN
This field is used to enable or disable the LAN signal to wake up the system.
After G3
This field is to specify what state to go when power is re-applied after a power failure
(G3 state).
S0 State
The system working state.
S5 State
System off, except for trickle current to devices such as the power button.
BGRT Logo
This field use to enable or disable to support display logo with ACPI BGRT table.
Wake on RTC
Wake On Real-time clock (RTC) allows the system to wake up from S4 or S5 states at
the configured time. When enabled, please also set up the Wake Up Time that follows
this field.
Wake up time
When Wake on RTC is enabled, this field will appear. Please configure the time (i.e.
hour, minute, and second) at which the system is specified to wake up.
Note:
BGRT Logo field will appear only when Quiet Boot is enabled. Refer to the Boot
menu later in this chapter for more information.
