DFI LANParty UT ICFX3200-T2/G, User Manual

Page: 160 / 183

5
160
RAID
The ATI SB600 chip alows configuring RAID on 4 Serial ATA drives.
It supports RAID 0, RAID 1 and RAID 0+1.
The Promise PDC40719 chip (LP UT ICFX3200-T2R/G only) allows
configuring RAID on another 4 Serial ATA ports. It supports RAID 0
RAID 1, RAID 0+1 and RAID 5.
RAID Levels
RAID 0 (Striped Disk Array without Fault Tolerance)
RAID 0 uses two new identical hard disk drives to read and write
data in parallel, interleaved stacks. Data is divided into stripes and
each stripe is written alternately between two disk drives. This
improves the I/O performance of the drives at different channel;
however it is not fault tolerant. A failed disk will result in data loss in
the disk array.
RAID 1 (Mirroring Disk Array with Fault Tolerance)
RAID 1 copies and maintains an identical image of the data from
one drive to the other drive. If a drive fails to function, the disk array
management software directs all applications to the other drive since
it contains a complete copy of the drive’s data. This enhances data
protection and increases fault tolerance to the entire system. Use
two new drives or an existing drive and a new drive but the size of
the new drive must be the same or larger than the existing drive.
RAID 0+1 (Striping and Mirroring)
RAID 0+1 is a combination of data striping and data mirroring
providing the benefits of both RAID 0 and RAID 1. Use four new
drives or an existing drive and three new drives for this configura-
tion.
RAID 5
RAID 5 stripes data and parity information across hard drives. It is
fault tolerant and provides better hard drive performance and more
storage capacity.
Chapter 5 - RAID