65
3
BIOS Setup
IDE HDD Block Mode
Enabled
The IDE HDD uses the block mode. The system BIOS
will check the hard disk drive for the maximum block
size the system can transfer. The block size will depend
on the type of hard disk drive.
Disabled
The IDE HDD uses the standard mode.
IDE DMA Transfer Access
This field is used to enable or disable the DMA transfer function of
an IDE hard drive.
On-Chip Primary PCI IDE and On-Chip Secondary PCI IDE
These fields allow you to enable or disable the primary and second-
ary IDE controller. The default is Enabled. Select Disabled if you want
to add a different hard drive controller.
IDE Recovery Time
This field is used to select the IDE recovery time.
IDE Primary Master/Slave UDMA and IDE Secondary Master/
Slave UDMA
These fields allow you to set the Ultra DMA in use. When Auto is
selected, the BIOS will select the best available option after checking
your hard drive or CD-ROM.
Auto
The BIOS will automatically detect the settings for
you.
Disabled
The BIOS will not detect these categories.
SATA Mode
IDE
This option configures the Serial ATA drives in IDE mode.
AHCI
This option configures the Serial ATA drives in AHCI
mode.
Summary of Contents for CT930-B
Page 1: ...CT930 B ECX Board User s Manual 935 CT9303 050G I01910743...
Page 16: ...16 2 Hardware Installation CT930 B solder side...
Page 102: ...102 4 Supported Software 3 Click Finish Reboot the system for DirectX to take effect...
Page 109: ...109 4 Supported Software 4 After completing installa tion click Finish to exit setup...