41
2
Hardware Installation
1
LAN
IDE Disk Drive Connector
The 44-pin IDE connector is for connecting up to two 2.5” hard
drives. To prevent improper IDE cable installation, the IDE connector
has a keying mechanism. The connector on the IDE cable can be
inserted only if pin 1 of the cable connector is aligned with pin 1 of
the IDE connector on the system board.
The IDE connector supports 2 devices, a Master and a Slave. Use
an IDE ribbon cable to connect the drives to the system board. An
IDE ribbon cable have 3 connectors on them, one that plugs into an
IDE connector on the system board and the other 2 connects to
IDE devices. The connector at the end of the cable is for the Master
drive and the connector in the middle of the cable is for the Slave
drive.
Note:
We do not recommend using IDE devices and CF card at the
same time.
4 4
4 3
2
1
X
Summary of Contents for CT930-B
Page 1: ...CT930 B ECX Board User s Manual 935 CT9303 050G I01910743...
Page 16: ...16 2 Hardware Installation CT930 B solder side...
Page 102: ...102 4 Supported Software 3 Click Finish Reboot the system for DirectX to take effect...
Page 109: ...109 4 Supported Software 4 After completing installa tion click Finish to exit setup...