2
Hardware Installation
43
PWR-LED: Power/Standby LED
This LED will light when the systems power is on. It will blink 4
times in every second when the system is in the S1 (POS - Power
On Suspend) state. It will blink every second when the system is in
the S3 (STR - Suspend To RAM) state.
Note:
If a system did not boot-up and the Power/Standby LED did
not light after it was powered-on, it may indicate that the CPU
or memory module was not installed properly. Please make
sure they are properly inserted into their corresponding socket.
Pin
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
HD-LED
(Primary/Secondary IDE LED)
G-LED
(Green LED)
ATX-SW
(ATX power switch)
G-SW
(Green switch)
RESET
(Reset switch)
SPEAKER
(Speaker connector)
PWR-LED
(Power/Standby LED)
Pin Assignment
HDD LED Power
HDD
N. C.
Green LED Power
Ground
N. C.
PWRBT+
PWRBT-
N. C.
SMI
Ground
H/W Reset
Ground
N. C.
Speaker Data
N. C.
Ground
Speaker Power
N. C.
LED Power (+)
N. C.
LED Power (-) or Standby Signal
N. C.
N. C.
This Manual: http://www.manuallib.com/file/2504586
