DFI CM33-EC, User Manual, Page: 39 / 89

2
38
Hardware Installation
The Wake-On-LAN connector is used to connect to a LAN card
that has the same connector. This function will allow the network to
remotely power-on a Soft Power Down (Soft-Off) PC. However, if
your system is in the Suspend mode, you can power-on the system
only through an IRQ or DMA interrupt.
To use the Wake-On-LAN function, you must enable “Resume on
LAN/Ring” in the Power Management Setup of the BIOS. Your LAN
card package should include a cable. Connect one end of the cable
to the wakeup header on the card and the other end to location J4
on the system board. The network will detect Magic Packet and
assert a wakeup signal to power-up the system. Refer to the add-in
card’s manual for details. Note: Your LAN card must support the
remote wake up function.
Important:
The 5VSB power source of your power supply must support a
minimum of
≥
720mA.
Pin
1
2
3
Function
+5VSB
Ground
WOL
2.6.14 Wake-On-LAN Connector
This Manual: http://www.manuallib.com/file/2504586