26
Factory Testing Jumpers
The jumpers below are for factory
testing only and should always
be set to their default configura-
tion. Reconfiguring these jumpers
will cause problems with your
system board.
JP14:
5-6 On, 7-8 On
JP30:
All Off
1
1
1
1. Enable this function by setting JP26 according to the COM port
where your modem is connected.
2. If your ATX power supply has an On/Off switch, set this to On so
that even when you have shut down (“soft power off”) your system,
it will always remain in “standby” mode. You can shut down your
computer by executing the Shut Down command under Windows
®
95.
3. Enable Power Management. This will allow your system to enter
Suspend mode after you have finished accessing data. Refer to the
Power Management Setup section for more information.
Important:
Before connecting your modem to COM 1 or COM 2, you must first turn
on the power of your modem. This is to protect your ATX power supply
against harmful interference.
2
3
2
3
2
3
Off: Disabled
(default)
2-3 On: COM 2
1-2 On: COM 1
