
20
2”. See Section 1.4.3 Adjustments & Sample LCD Displays Step 4. (Adjust photo sensor
position if photo registration and pre-printed sleeves are being used).
15.
Repeat steps 14 to 18 until correct sleeve length is achieved.
16.
Send four products through the machine and check the fourth product for sleeve application.
17.
If necessary, adjust the product sensor to achieve central placement of the sleeve/band over
the product. If the sleeve is delivered too early move the sensor in the direction of the
product flow. If the sleeve is delivered too late move the sensor against the direction of the
product flow.
18.
Finally adjust the brushes to obtain the correct wipedown height of sleeve above the top of
cap. Check the result after shrinking in the heat tunnel. If long neck sleeves or full body
sleeves are being used adjust the wipedown flails such that wipedown to the product shoulder
or to conveyor level is achieved as appropriate.
Summary of Contents for NSV-400
Page 3: ...4 1 3 BASIC BLUEPRINTS...