DFC NSV-400, Operation Manual & Product Specifications

Page: 15 / 26

16
2.4 F
ILM
C
UTTING
U
NIT

The film is cut by a set of servo operated rotating blade, controlled by a P.L.C through sets of
gear and belt.

After the film is cut, it will be pushed down to just above the applicating driver. The film will
stay there until the new film is being cut, and pushed it down to the applicating driver.

The cutting stroke is initiated by a signal generated immediately after the material feed is
complete.
Adjusting Blade Position
Only adjust the blade cutting position if the blade does not turned away after cutting action which
continuously jams the material in the cutting unit.

To adjust blade positioning, first lossen the belt tensioner, so you can move the Cutting Unit
Belt freely.

Adjust the blade position by taking out the knife set and then, move l the blade is 180° away
from the mandrel.
D
RIVER
R
OLLER
A
DJUSTMENT
P
ROCEDURES
Maximum material wide – 160 mm layflat
Minimum material thickness – 40 micron
Maximum material thickness – 80 micron