Bath Cycle Time “ct”
0 to 15 minutes for Prewash, Rinse1 and Rinse 3 to 15 minutes for Wash and Final Rinse. For the
baths that can, if the time is set to zero, then that bath will be eliminated from the cycle.
Bath Water Temperature “t”
HH – hot, CH – warm, CC – cold, EE – no water. The owner can set the bath default. For the wash
bath, the default is over ridden for that cycle by the customer when the temperature is selected.
Bath Water Level “L”
LO – low The owner can change the displayed value, but for a coinwasher only LO will be put into
the cycle.
Bath Delay Fill “dF”
The selections are “d” for delay the bath time until water level is reached or “t” for decrement bath
time during the fill.
Bath Spin Time “S”
0 to 10 minutes for Prewash, Wash, Rinse1 and Rinse2 1 to 10 minutes for Final Spin.
Bath “IS”
The owner can change the displayed value, but for a coin washer only 0 will be put into the cycle.
Washer 6 Default Cycles (Preset at Factory)
There are 6 pre programmed baths on the control which are set up at the factory. The
formulas for each are shown on the following pages. Each of these 6 programs can be
adjusted and saved as the owner needs.
33
Part # 8533-075-001 6/22
32
Part # 8533-075-001 6/22
Section 3:
Machine
Programming
Instructions
Machine
Mounting
Installation
& Operation
Programming
Trouble-
shooting
Machine
Service
Electrical
Wiring
Parts
Data
50Hz
Parts
Maintenance
Service Elec.
Compnents