Washer Operating Instructions
Safety Door Lock
This machine is equipped with a Safety Door Lock that locks the door closed from when the cycle is
started until the cycle is complete. The door lock prevents opening the door for up to 3 minutes if the
power is interrupted during the cycle.
Starting the Washer
A. Load the items to be washed in the cylinder and latch the door securely. Be sure clothing does
not get caught between the door gasket and tub front when closing the door.
NOTE: To close the door the handle must be in the horizontal position and then moved
to the vertical position . After moving the door to the closed position, the handle must be
turned down to the vertical position to latch the door for machine operation.
B. Make the appropriate cycle selection for the wash load by pushing the up and down arrows on the
touch pad. Preprogrammed Cycles 1,2,3,4,5, or 6. Each cycle is completely programmable and for
instructions see next section in this manual.
C. To manually add wash compounds, pour low-sudsing powdered detergent into the detergent
dispenser on front of the machine. Rinse conditioners may also be added to the dispenser. The
correct location of each is shown on the dispenser lid.
D. To manually add bleach in Rinse, pour bleach in opening. Bleach light will come on during the
wash bath only (location shown on dispenser lid) in top or front of washer.
E. To start the washer, push the green “Start” button
F. To pause for an extended soak, push the red Stop button for 1 second. To continue the cycle,
push the green Start button.
enough to reach down to water trap.
G. To stop and clear the wash cycle, hold the red Stop button for 8 to 10 seconds.
H. If automatic chemical injection systems are being used, make sure that chemical hoses are
inserted correctly in the injection port located at rear corner at red cover. Hoses must be inserted
long enough to reach down to water trap.
Safety Door Lock
If power is interrupted the Safety Door Lock delays opening the door until it is safe to do so. If power
failure occurs or if power is interrupted during maintenance, it will be necessary to wait 2 to 3 minutes
before the door can be opened.
End of Cycle
When the cycle is completed, the washer will stop, the End of Cycle Light will come on, the Buzzer sounds
and the loading door will unlock. It can be opened by turning the door handle to the indicated position
and pulling. Leave the clothes door open when the machine is not in use helps to eliminate odors that
might build up during the wash process.
Detergent Measurements By
Washer Model
1/2 Cup
Mega Load T-900 Washer
Magnum Load T-1200 Washer
Maxi Load T-750 Washer
Mega Load T-950 Washer
Magnum Load T-1450 Washer
2/3 Cup
1/3 Cup
1/2 Cup
1/2 Cup
28
29
Part # 8533-075-001 6/22
Part # 8533-075-001 6/22
Machine
Mounting
Installation
& Operation
Programming
Trouble-
shooting
Machine
Service
Electrical
Wiring
Parts
Data
50Hz
Parts
Maintenance
Service Elec.
Compnents
