20
in the dryer controller by pressing the default settings pushbutton on the back (component) side of the
dryer controller circuit board. It is labeled and located at the lower middle side of the printed circuit
board, as you face the component side of the board. It must be pressed and held down for at least three
seconds.
To permanently change a dryer controller cycle, follow the procedure below. Things that are displayed
on the 4-digit numeric display will be in “quotation marks”. Keys on the touch pad that physically need
to be pressed will be in
CAPITAL AND BOLD LETTERS
.
If, at any time, you want to escape the permanent programming mode while changing the settings, you
can press the
STOP
key on the dryer controller touch pad if the 4-digit numeric display is not flashing.
The
SELECT/ENTER
key on the dryer controller touch pad can be pressed and released to enter the
flashing value shown on the 4-digit numeric display and allow you to escape.
PROCEDURE
1)
Make sure the dryer is not in a dry cycle. The 4-digit numeric display on the dryer controller will
show “LOAd” when the dryer is not in a dry cycle.
2)
Press and release the
PROG
key on the dryer controller touch pad.
3)
Press and release the
UP
arrow key on the dryer controller touch pad. The programming L.E.D. will
illuminate and the 4-digit numeric display on the dryer controller will change to “Prog”.
4)
Press and release the
UP
or
DOWN
arrow keys to choose the dry cycle you want to change (dry cycle
1 through 5). The dry cycle L.E.D. will illuminate to indicate which dry cycle you are choosing. If
you press either arrow key and hold it down, the controller will sequence through the five dry cycles.
5)
Press and release the
SELECT/ENTER
key once you have chosen the dry cycle you want to change.
After you press this key, the dry time L.E.D. will illuminate. The dry cycle L.E.D. and the
programming L.E.D. will remain illuminated. The total dry time will also be displayed on the 4-digit
numeric display.
6)
Press and release the
UP
or
DOWN
arrow keys to change the total dry time. Once either of the arrow
keys is pressed, the dry time L.E.D. and the total dry time on the 4-digit numeric display will flash. If
you press and hold either arrow key down, you will increment (
UP
arrow) or decrement (
DOWN
arrow) through the total dry times available (1 through 60 minutes). This displayed dry time includes
the cool down time along with the heated time. To not change the total dry time, do not press the
arrow keys. Go to the next step.
7)
Press and release the
SELECT/ENTER
key. Once this key is pressed and released, the dry time
L.E.D. will switch off, the dry cycle L.E.D. and programming L.E.D. will remain on, and the
temperature L.E.D. will illuminate. The drying temperature will also be shown on the 4-digit numeric
display.
8)
Press and release the
UP
or
DOWN
arrow keys to change the drying temperature. Each press and
release of the arrow keys will either increase or decrease the temperature by five degrees Fahrenheit
or three degrees Celsius, depending on how your dryer controller is set up. Once either of the arrow
keys is pressed, the temperature L.E.D. and the drying temperature on the 4-digit numeric display will
Summary of Contents for DDAD30HC-59 Series Dryers
Page 3: ...3 Figure 1 30 Stack Dryer Dimensions inches mm ...
Page 11: ...11 ...
