17
The temporary programming mode will allow the change of the stored dry cycle settings in the dryer
controller for one complete dry cycle. After the dry cycle is complete, the default settings that existed
before the temporary change are restored. The temporary dry cycle can be stopped and cleared at any
time during the dry cycle operation.
To temporarily change a dryer controller cycle, follow the procedures below. Things that are displayed
on the 4-digit numeric display will be in “quotation marks”. Keys on the dryer controller touch pad that
physically need to be pressed will be in
CAPITAL AND BOLD LETTERS
.
If, at any time, you want to escape the temporary programming mode while changing the program
settings, you can press the
STOP
key on the dryer controller touch pad if the 4-digit numeric display is
not flashing. The
SELECT/ENTER
key on the dryer controller touch pad can be pressed and released to
enter the flashing value shown on the 4-digit numeric display and allow you to escape.
If you press and release the
STOP
key on the dryer controller touch pad, when the 4-digit numeric
display is not flashing, the temporary changes to the dry cycle program will be cancelled. The stored dry
cycle settings that existed before the temporary change will then be restored.
If, at any time, you want to start the temporary dry cycle during the temporary programming mode,
press and release the
START
key on the dryer controller touch pad if the 4-digit numeric display is not
flashing. The
SELECT/ENTER
key on the dryer controller touch pad can be pressed and released to
enter the flashing value shown on the 4-digit numeric display and allow you to start the temporary dry
cycle. If you start the temporary dry cycle, the 4-digit numerical display will change to the total dry time
and count down to 0 as the dry cycle progresses.
PROCEDURE
1)
Make sure the dryer is not in a dry cycle. The 4-digit numeric display on the dryer controller will
show “LOAd” when the dryer is not in a dry cycle.
2)
Press and release the
UP
or
DOWN
arrow keys on the dryer controller touch pad to chose the dry
cycle that you want to change (dry cycle 1 through 5). The dry cycle L.E.D. will illuminate to
indicate which dry cycle you are choosing. If you press either arrow key and hold it down, the
controller will sequence through the five dry cycles.
3)
Press and release the
CYCLE
key on the dryer controller touch pad once you have chosen the dry
cycle you want to change. After you press this key, the programming L.E.D. and the dry time L.E.D.
will illuminate. The dry cycle L.E.D. will remain illuminated. The total dry time will also be
displayed on the 4-digit numeric display.
4)
Press and release the
UP
or
DOWN
arrow keys to change the total cycle time. Once either of the
arrow keys is pressed, the dry time L.E.D. and the total dry time on the 4-digit numeric display will
flash. If you press and hold either arrow key down, you will increment (
UP
arrow) or decrement
(
DOWN
arrow) through the total dry times available (1 through 60 minutes). This displayed dry time
includes the cool down time along with the heated time. To not change the total dry time, do not press
the arrow keys to change the total dry time.
5)
Press and release the
SELECT/ENTER
key. Once this key is pressed and released, the dry time
L.E.D. will switch off, the dry cycle L.E.D. and programming L.E.D. will remain on, and the
temperature L.E.D. will illuminate. The drying temperature will also be shown on the 4-digit numeric
Summary of Contents for DDAD30HC-59 Series Dryers
Page 3: ...3 Figure 1 30 Stack Dryer Dimensions inches mm ...
Page 11: ...11 ...
