Installation
ECO BETADRIVE ECO
16
81417 2.0
5.2
Installation procedure
NOTICE
Carry out the assembly of the drive when the application is in no-load position.
In its final position, the drive must be either fully retracted or extended.
Damage to the drive is prevented
only
in in no-load position and a safe assembly is ensured.
An example installation
First example: Profile cap with mounting bracket / clevis with mounting bracket.
Figure 8
Installing the drive (example)
A
End product
B
Adaption mechanism of the end product
C
Mounting bracker on the side of the profile
cap
D
Mounting bracket on the side of the clevis
E
Actuating block
F
Self-tapping screw
Ø
6,3 x max.25mm
(DIN EN ISO 1478)
In the following example, installation of the ECO BETADRIVE ECO into the end product is shown.
Certain details may change as a result of technical changes.
1
Move your product into a position where it is supporting no load.
2
Put the drive onto the end product
(A)
.
3
Screw the mounting bracket
(C / D)
onto the end product
(A)
.
4
Screw the adaptive mechanism
(B)
to the actuating block
(E)
.
Use self-tapping screws
Ø
6.3 x max.25 mm (DIN EN ISO 1478).
Recommended torque
for the self-tapping screws: Max. 6 Nm
5
You may now connect the ECO BETADRIVE ECO electrical connection.
F
B
C
E
A
B
A
D
