9
WARNING:
If the belt sander in the
FIG. 10
Y
X
V
W
inversion stand is in the horizontal
position, be sure guard (Y) is covering
the space between the belt and the rear
of the housing as shown in Figure 10.
Otherwise, serious injury could result.
WARNING:
If the belt sander in the
inversion stand is in the horizontal
position, hold wood firmly during
sanding. The belt may pull the material
away from you resulting in injury.
VACUUM ADAPTER—DW4050 (SOLD
SEPARATELY)
Your belt sander can be attached to a 32 mm (1-1/4") shop vacuum hose for dust
collection.
To Attach the Vacuum Adaptor to the Belt Sander
1. Pull up on the dust seal latch (P), shown in Figure 5,
FIG. 11
and remove the dust chute and dust bag from the belt
sander.
2. Insert the vacuum adapter (Fig. 7) into the dust
ejection port and push the latch closed securing the
adapter to the sander.
3. Attach the vacuum to the adapter.
WARNING:
The use of a vacuum hose and vacuum
adapter with the belt sander may generate static electricity
that could result in startling static discharge.
MAINTENANCE
WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect tool from power source before making any adjustments or removing/
installing attachments or accessories.
Before reconnecting the tool, depress and
release the trigger switch to ensure that the tool is off. An accidental start-up can
cause injury.
To Remove the Brushes
The brushes on your belt sander may require replacement at some point during the
life of the tool. Contact your local D
E
Walt authorized service centre to obtain additional
brushes.
1. To remove the brush cover (C, Fig. 1), use a flat head screwdriver or a T20
TorxBit.
2. Remove the brushes.
To Install a New Platen/Cork on Your Belt Sander
The cork under the platen on your belt sander may require replacement at some point
during the life of the tool. A new platen/cork is available through your D
E
Walt service
centre.
1. Remove the sanding belt from the sander as described in
Assembly
.
2. Use an M3 hex wrench to remove the existing steel platen/cork on the underside
of the unit.
3. Attach the new platen/cork to the sander and discard the old one.
4. Install a sanding belt as described in
Assembly
.
Lubrication
Self lubricating ball and roller bearings are used in the tool and relubrication is not
required. However, it is recommended that, once a year, you take or send the tool to a
D
E
WALT certified service centre for a thorough cleaning, inspection and lubrication of
the gear case.
Cleaning
WARNING:
Blow dirt and dust out of all air vents with clean, dry air at least once
a week. To minimize the risk of eye injury, always wear AS/NZS1337 approved eye
protection when performing this.
WARNING:
Never use solvents or other harsh chemicals for cleaning the
non-metallic parts of the tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with water and mild soap. Never let
any liquid get inside the tool; never immerse any part of the tool into a liquid.
Summary of Contents for DW433-XE
