17
English
notE:
After approximately 20 hours of operation, accessory bolts may
loosen. Tighten them as needed.
HH
BB
GG
AA
FF
DD
LL
MM
JJ
KK
EE
Wheel Kit Assembly
CAUTION:
Risk from lifting.The generator is too heavy to be lifted
by one person. Obtain assistance from others before lifting.
1. Carefully tilt the generator so
EE
AA
KK
DD
FF
GG
BB
it rests on the engine side.
2. Install the two stands (AA) at
the lower chassis. Install the
wheel axle (BB) to the upper
chassis. Use the bolts (KK) for
these two steps.
3. Insert the two larger washers
(DD) on each end of the axle.
Slide the tires (EE) on the
axle.
4. Insert the two small washers (FF) on the outside of the wheels and
secure with cotter pins (GG).
5. Place the generator upright so it is resting on the wheels and
stands.
handle Kit Assembly
1. Install handles on the engine side of the
HH
KK
JJ
generator by placing the handle assembly
(HH) on the top horizontal bars and then
inserting the bottom clamp (JJ).
2. Use the bolts (KK) to secure the bottom
clamp to the top clamp.
3. Tighten the bolts until the assembly is
snug or until the gap between the top and
bottom clamps is closed.
Lifting hook Assembly
1. Insert the lifting hook (MM) under the two horizontal bars and posi
-
tion it as shown.
MM
LL
KK
2. Place the top clamp (LL) over the horizontal bars and fasten to the
lifting hook using the bolts (KK).
3. Position the lifting hook as shown and adjust to the correct location
per model:
DG4400B, DG4400BC, DG6300B, DG6300BC
- Place the edge
of the lifting hook 12.5" (31.8 cm) from the edge of the frame as
shown.
DG7000B, DG7000BC
- Place the edge of the lifting hook 12.25"
(31.1 cm) from the edge of the frame as shown.
4. Tighten the bolts firmly until the gap between the top clamp and
the lifting hook is closed.
