DEVO-7 Page 118 of 170
L,1,2,M,3,4 and H7. Press DN to enter POINT OUTPUT setting, press R or L to set
the value you want.
Press UP to back to contiune to set other points value.
4
）
Throttle lever setting: after point setting is finished, press DN to enter into Throttle
lever interface. There are two setting, inhabit and Throttle lever postion. Press R to
choose INB and choose L to decrease value. The value is covered from 0.0% to
100.0%. The default setting of throttle lever is Inhibit
It’s possible to switch throttle lever between POS1 and POS0 after setting finished.
The data you set is both throttle lever position and turning point.
5)switch selection:
It’s possible to switch between POS0 and POS1 when throttle lever item is inhabited.
Setting: After throttle lever is finished, please press DN to enter into position setting
interface as below, which shows the switch status.
