Deutz EMR 2, System Description, Page: 49 / 60

© 06/02
Page 107
1
2
3
4
5
6
7
8
9
10
11
12
13
EMR 2
Index of Specialist Terms
10 Index of Specialist Terms
AGR Exhaust gas return
Actuator Actuator
AMP plug Multi-pole plug of the AMP company
Baud rate Data transmission speed [Bit/s]
CAN-Bus Interface (Controler Area Network)
EDC-actuator Actuator of the Bosch company
EEPROM Memory module in the microprocessor
EER 2 Electronic engine governer
ELTAB Electronic engine pocket handbook
EMV Electromagnetic compatibility
F-plug Vehicle plug / plant-side plug at the control unit
GND Mass (Ground)
High Switch open (high)
ISO International Standard Organization
Clamp 31 Minus clamp at battery
KLU Scope of customer supply
KM-temperature Coolant temperature
LDA Charge air pressure dependent full load stop
Limp home Emergency running features
Load dump Noise limit
Low Switch closed (low)
M-plug Engine plug
M
d
Torque
NC Not assigned
NTC Negative temperature coefficient
P-grad Proportional gradient; P-grad = 0 (Isochronous); P-grad adjustable (Droop).
PID control Proportional, integral, differential parts of the control
Pin Plug pin
Pull-up resistance Resistance to supply voltage
PWM-signal Pulse width modulated signal
REF Reference voltage or potential
SERDIA DEUTZ service diagnosis software with interface
Setpoint Setpoint
SWG 1/2 Setpoint sensor 1/2