2
3
Assembly Instructions
Safety Instructions
Maintenance and Storage
Wiring Diagram
Chassis
Cutter Asembly
Handle Bars & Controls
Gearbox Assembly
Fuel Tank / Sundry Parts
Warranty
INDEX
3
5
7
13
14
15
16
17
19
20
ASSEMBLY INSTRUCTIONS
HANDLE ATTACHMENT
(Pre delivery) (Refer to Figure 1)
1. Connect the handles to the side rails of the chassis using four 75mm M8 bolts, while making sure that the ball
on gearbox linkage “ A” connects with the slotted tubular lever “B.” The ball and the tube should be greased to
make gear changes easier. The 75mm bolt through the rear hole on the right of the mower (facing forward) will
need to be inserted from underneath. Fasten the four nuts securely.
2. Insert a _” circlip into the groove in the end of the tubular lever “B”.
3. Fully loosen nut “C” and connect rod “D” to the drive clutch lever “E” using the washer and split pin. Retighten
nut “C”.
4. Connect the clutch return spring to the top of the drive clutch lever and to pin “F”.
5. Connect the rod “G” to the foot pedal assembly using a washer and split pin.
6. Connect the height adjusting rod H to the curved lever “J” using the bolt nut and washer provided.
7.
See Figure 2
. Place tank straps “L” in the tank bracket “K” slots and bend tabs up and back against the
bracket. Bolt the tank bracket to the handle bar assembly using three round headed bolts, with the round heads
of two bolts against the fuel tank. Place the fuel tank in position and attach the straps at their lower end using
two bolts.
8. Attach the throttle control to the handle bars ensuring the cable is free of sharp bends. Ensure both “choke”
and “stop” positions are achieved using the throttle lever.
9. Connect the fuel line from the tank to the engine.
Fig. 1 - Dealer Assembly
A
B
C
D
E
F
G
H
J
