8525-0377-0M Rev A
x
8432-CH Owner’s
8
BATTERY OPERATION, CONT.
Battery Installation/Replacement
To install or remove the batteries, the
following steps should be followed:
1.
Make sure the AC power adapter is
unplugged.
2.
Remove the indicator from the scale
column bracket. (Referring to Figure No.
6, pull the spring plunger down and slide
the indicator up and away from the
bracket).
3.
Turn the indicator over so that the
display is facing away from you.
4.
Locate the rectangular panel on the
back of the indicator.
5.
To install or replace the batteries, first
remove the battery holder cover by
pushing in on the tab and lifting it up.
Refer to Figure No. 7.
6.
If installing new batteries, proceed to
step 7. If replacing the batteries, remove
all 6 batteries from the battery holder
and then proceed to step 7.
7.
Install the 6 new “AA” size batteries in
the battery holder, noting the polarity
markings located in the battery holder.
Refer to Figure No. 8.
8.
After placing all 6 batteries in the holder,
replace the battery cover.
9.
Turn the indicator over (display facing
up) and press the
ON/OFF
key.
10.
If the display turns on, the batteries
have been installed correctly. If not,
remove the panel and check for one or
more improperly positioned batteries.
11.
Return the indicator to the scale column
bracket. Refer to the steps on page 3.
12.
The scale is now ready for operation.
For more information on setup and
operation of the indicator, see the
750 Owner’s Manual (8555-M483-O1).
Spring
Plunger
Release
Figure No. 6
Figure No. 7
- +
+ -
+ -
+ -
- +
- +
Figure No. 8
Battery
Cover
Push in and
lift here
