Desoutter EABC15-900-eLINK, Product Instructions, Page: 26 / 28

Troubleshooting EN
26 / 28 07/2020
Number Description Procedure
I210 Invalid Pset selected 1- The selected Pset does not match the Pset selectable
in the Assembly Process.
I211 Invalid trigger configuration 1- The tool connected to the system is not equipped
with the trigger required by the trigger configuration.
2- Adjust your trigger configuration to the tool or
change the tool according to the trigger configuration.
I224 IGBT too hot 1- Power electronics too warm.
2- Let the system cool down.
I251 No Pset selected 1- No Pset selected.
2- Select a Pset.
I270 Time settings 1-Invalid Time setting|2-Check Pset settings with cor-
rect time value settings
W010 Tool calibration expired 1- The tool calibration date has expired.
2- A tool calibration needs to be done to ensure the
measurement accuracy.
W028 Battery tool version error 1 - Battery tool version and system version are not
compatible.
W030 The battery is low. 1- The battery is low.
2- Recharge the battery.
W033 Tool time error 1- The tool time is not set correctly. The tightening re-
sults will not be time stamped.
2- Connect the tool to the system to set date and time.
W036 Tool memory full 1- The tool memory is full.
2- Connect the tool to the system to empty the mem-
ory.
W062 Overload of torque 1- Overload of the torque (could be a rehit).
2- Check the tool cable is not damaged.
W212 Result not stored 1- It is not possible to store the tightening result in the
system.
2- Contact your Desoutter representative for support.
W216 Current high 1- Maximum current exceeded.
2- Contact your Desoutter representative for support.
W267 Result transfer error Result transfer error.
E007 Motor too hot 1- Tool is locked because the maximum motor temper-
ature has been reached.
2- Tool will remain locked until the motor temperature
comes back to its normal value.
E008 Tool angle fault 1- Problem detected with the tool angle sensor.
2- The tool needs maintenance.
E009 Tool invalid parameters 1- Check the tool compatiblity.
2- The tool memory cannot be read or is invalid.
3- The tool needs maintenance. If the problem occurs
again, contact your Desoutter representative for sup-
port.
E012 Tool EEPROM error 1- The tool memory cannot be read or is invalid.
2- The tool needs maintenance. If the problem occurs
again, contact your Desoutter representative for sup-
port.
E018 Torque out of range ! 1- The target torque value is above the tool maximum
torque.
2- Check Pset settings with tool characteristics.
E029 The battery is empty. 1- The battery back is discharged. The tool cannot
tighten.
2- Recharge the battery pack.
E031 Battery error 1- Abnormal battery voltage. The tool cannot tighten.
2- Recharge the battery pack. If the problem occurs
again, replace the battery pack.