www.desatech.com
121341-01A
3
Back View
FIlleR PANel Assembly (FOR Use WItH style
seleCtIONs GAs FIRePlACe ONly)
If you are installing a Style Selections Gas Fireplace in this
mantel, you will need to follow the instructions in this section.
If you are not installing a Style Selections Gas Fireplace, go
to
Mantel Top Assembly
and discard items #14 and #15.
1. Place Style Selections filler panel (#14) in position in front
of mantel with trim strip to outside covering joint between
filler panel and mantel (see Figure 4).
2. With one person holding filler panel in place, attach filler
assembly (#14) to bottom of header mantel side using 3
filler panel blocks #15 and six 1
1
/
4
" screws with washers
(see Figure 4). Do not tighten screws.
Figure 5 - attaching mantel top
1
1
/
4
"
Screw
Washer
Mantel Top (#7)
Mantel
Side
Assembly
mANtel tOP Assembly
Place mantel top (#7) on mantel assembly. Align back of top
with back of sides. Using seven 1
1
/
4
" screws with washers,
place two in each mantel side assembly and three in the header
(see Figure 5). Make sure all pieces are aligned properly and
tighten all seven screws.
Filler Panel (#14)
1
1
/
4
" Screw with Washer
Figure 4 - attaching Style Selections Filler panel
eleCtRIC FIRePlACe INstAllAtION
This mantel can be used with a 26" intermediate Fireplace.
Electric fireplaces install from the front of mantel. To install
electric fireplace see fireplace instruction manual.
Filler Panel (#14)
