www.desatech.com
108660-01E
18
3. Keeping folded door tilted,
slide upper
two pins into the guide track found under
upper facial edge of firebox opening.
4. Tilt door assembly fully vertical until outer
pivot pin snaps into mounting hole in upper
spring clip (see Figure 33, page 17).
5. Once top and bottom pins are secured,
unfold door into closed position.
6. Repeat process for opposite door
assembly.
7. To adjust doors, slide them partially open.
Using a screwdriver, loosen thehold-down
screws in spring clip (see Figure 34) and
pivot plate.
8. Close both doors until evenly joined at
the middle and note gap at outer edges
of face.
9. Reopen one door at a time and retighten
upper and lower hold-down screws.
10. Repeat process until both doors are even-
ly joined, spaced and working freely.
CAUTION: Glass panels
become very hot while the ap-
pliance is operating. Do not
attempt to adjust or clean glass
doors until appliance has fully
cooled.
INSTALLATION
Continued
Figure 34 - Adjusting Glass Doors
Spring Clip
Hold-Down
Screw
Side
Front
Face
Partially
Opened
Door
Figure 35 - Removing Glass Doors
Spring
Clip
Press Spring Clip
to Release Pivot
Pin
Remove
Bottom
Pin From
Pivot Plate
While
Sliding
Door Out
of the
Upper
Track
Pivot Plate
Fold Bi-Fold Door
After Releasing
Spring Clip and
Slide Door Out of
Upper Track
Doors may be removed for replacement or
cleaning as follows:
1. Partially open door and press up on the
upper spring clip with a screw driver until
outer top pivot pin is free of clip.
. Fully fold frame assembly and slide up-
per edge toward center of firebox open
-
ing until guide pins are free of frame rail
(see Figure 35).
CAUTION: Always operate
appliance with doors either fully
opened or fully closed. Operat-
ing appliance with doors par-
tially open can result in improper
venting of flue products.
