![background image](http://html1.mh-extra.com/html/desa/v-dvf36tclp-e/v-dvf36tclp-e_owners-operation-and-installation-manual_2486233027.webp)
www.desatech.com
112108-01C
2
OFF
P
IL
O
T
ON
LO
HI
P
ILOT
E
A
16AI
7
TPTH
TP
TH
Gas Control
Knob
Flame Adjustment
Knob
Position
Indicator
Figure 56 - Millivolt Control Valve
Figure 57 - Pilot
Thermopile
Pilot Burner
Piezo Ignitor
Thermocouple
6. Wait five (5) minutes to clear out any gas.
Then smell for gas, including near the floor.
if you smell gas, SToP! Follow “B” in the
safety information, page 28. if you don’t
smell gas, go to the next step.
7. Turn knob on gas control counterclockwise
to PiLoT.
8. Push in the control knob all the way and
hold in. immediately light the pilot by
pressing the ignitor button until a flame
appears 1 minute after the pilot is lit. The
pilot is located by the main burner. release
knob and it will pop back up. Pilot should
remain lit. if it goes out, repeat steps 5
through 8.
• if knob does not pop out when released,
stop and call gas supplier.
• if the pilot will not stay lit after several tries,
turn gas control knob to oFF and call your
service technician or gas supplier.
9. Turn gas control knob counterclockwise
to “N. Knob can be turned to oN
only if the control knob is popped out.
10. Set hi-Lo knob to desired setting.
11. Turn on all electric power to the appliance.
TO TURN OFF GAS
TO APPLIANCE
1. Turn off the wall switch.
2. Turn off all electric power to the appliance
if service is to be performed.
OPERATING FIREPLACE
Continued
3. remove control access panel.
4. Push in gas control knob slightly and turn
clockwise
to oFF. Do not force.
5. replace control access panel.
ELECTRONIC
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
a fire or explosion may result
causing property damage, per
-
sonal injury or loss of life.
A. This appliance has a pilot which must be
lighted by hand. When lighting the pilot,
follow these instructions exactly.
B. BeFore LiGhTiNG smell all around the
appliance area for gas. Be sure to smell next
to the floor because some gas is heavier than
air and will settle on the floor.
WhAT To Do iF YoU SMeLL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not
use any phone in your building.
• immediately call your gas supplier from
a neighbor’s phone. Follow the gas
supplier’s instructions.
• if you cannot reach your gas supplier, call
the fire department.
C. Use only your hand to push in or turn the
gas control knob. Never use tools. if the
knob will not push in or turn by hand, don’t
try to repair it, call a qualified service tech
-
nician or gas supplier. Force or attempted
repair may result in a fire or explosion.
D. Do not use this appliance if any part has
been under water. immediately call a
qualified service technician to inspect the
appliance and to replace any part of the
control system and any gas control which
has been under water.
LIGHTING
INSTRUCTIONS
1. SToP! read the safety information before
proceeding.
2. Set thermostat to lowest setting (if appli-
cable).
3. Turn off wall switch.
4. open control access panel or louver.