![background image](http://html1.mh-extra.com/html/desa/v-dvf36tclp-e/v-dvf36tclp-e_owners-operation-and-installation-manual_2486233026.webp)
www.desatech.com
112108-01C
26
3. If replacement is necessary, the entire assem-
bly (frame and glass) must be replaced. If glass
is broken, wear gloves and tape remaining
fragments onto the frame. Remove 5 screws
located on end of firebox while holding frame
assembly to prevent it from falling and caus-
ing injury (see Figure 54). Mount new frame
at hinge with 5 new screws. Close and latch
door. This will seat the gasket. If replacing end
glass panel, remove 16 screws around frame
(see Figure 55) To insure proper fit, when
installing new glass panels make sure seam
in gasket is placed in the down position.
4. Replace screen assembly and top and bottom
louvers.
CLEANING AND
MAINTENANCE
Continued
Figure 54 - Removing Glass Door
Figure 55 - End Panel Replacement
Glass
Assembly
Frame
Assembly
Louver Assembly
Retainer Screws
Screws
Hinge
OPERATING FIREPLACE
MILLIVOLT
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
a fire or explosion may result
causing property damage, per
-
sonal injury or loss of life.
A. This appliance has a pilot which must be
lighted by hand. When lighting the pilot,
follow these instructions exactly.
B. BeFore LiGhTiNG smell all around the
appliance area for gas. Be sure to smell next
to the floor because some gas is heavier than
air and will settle on the floor.
WhAT To Do iF YoU SMeLL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not
use any phone in your building.
• immediately call your gas supplier from
a neighbor’s phone. Follow the gas
supplier’s instructions.
• if you cannot reach your gas supplier, call
the fire department.
C. Use only your hand to push in or turn the
gas control knob. Never use tools. if the
knob will not push in or turn by hand, don’t
try to repair it, call a qualified service tech
-
nician or gas supplier. Force or attempted
repair may result in a fire or explosion.
D. Do not use this appliance if any part has
been under water. immediately call a
qualified service technician to inspect the
appliance and to replace any part of the
control system and any gas control which
has been under water.
LIGHTING
INSTRUCTIONS
1. SToP! read the safety information begin-
ning above before proceeding.
2. Set the hi-Lo knob to the lowest setting.
3. Turn off all electrical power to the appliance.
4. open control access panel.
5. Push in gas control knob slightly and turn
clockwise
to oFF.