![background image](http://html1.mh-extra.com/html/desa/v-dvf36tclp-e/v-dvf36tclp-e_owners-operation-and-installation-manual_2486233010.webp)
www.desatech.com
112108-01C
10
VENTING INSTALLATION
INSTRUCTIONS
WARNING: Read all instruc-
tions completely and thoroughly
before attempting installation.
Failure to do so could result in
serious injury, property damage
or loss of life.
WARNING: Seal all connec-
tions with high temperature
silicone every time a vent con-
nection is made. Before joining
elbows or pipes, apply a bead
of high temperature silicone
sealant to the male end of the
elbow or pipe. High temperature
silicone must also be used to re
-
seal any connections after main-
tenance to venting system.
NOTICE: Failure to follow these in-
structions will void the warranty.
NOTICE: Do not seal termination
cap to vent pipe. Cap must be
removable for vent inspection
and maintenance.
INSTALLATION
PRECAUTIONS
Consult local building codes before beginning the
installation. The installer must make sure to select
the proper vent system for installation. Before
installing vent kit, the installer must read this
fireplace manual and vent kit instructions.
Only a qualified service person should install
venting system. The installer must follow these
safety rules:
• Wear gloves and safety glasses for protection
• Use extreme caution when using ladders or
when on roof tops
• Be aware of electrical wiring locations in walls
and ceilings
The following actions will void the warranty on
your venting system:
• Installation of any damaged venting component
• Unauthorized modification of the venting sys-
tem (Do not cut or alter vent components)
• Installation of any component part not manu-
factured or approved by DESA
• Installation other than as instructed by these
instructions
WARNING: This gas fireplace
and vent assembly must be vented
directly to the outside. The venting
system must NEVER be attached
to a chimney serving a separate
solid fuel burning appliance. Each
direct-vent gas appliance must
use a separate vent system. Do not
use common vent systems.
INSTALLATION PLANNING
There are two basic types of direct-vent installation:
• Horizontal Termination
• Vertical Termination
It is important to select the proper length of vent
pipe for the type of termination you choose. It is
also important to note the wall thickness.
For Horizontal Termination:
Select the amount of
vertical rise desired. The horizontal run of venting
must have 1/4" rise for every 12" of run towards
the termination.
WARNING: Never run the
vent downward as this may
cause excessive temperatures
which could cause a fire.
You may use one or two 90° elbows in this vent
configuration. See
Horizontal Termination Con-
figurations
on page 13.
For Vertical Termination:
Measure the distance
from the fireplace flue outlet to the ceiling. Add
the ceiling thickness, the vertical rise in an attic or
second story, and allow for sufficient vent height
above the roof line. You may use one or two 90°
elbows in this vent configuration. See
Vertical
Termination Configurations
on page 16.
Note:
You may use two 45° elbows in place of a
90° elbow. You must follow rise to run ratios when
using 45° elbows.
For two-story applications, firestops are required at
each floor level. If an offset is needed in the attic,
additional pipe and elbows will be required.
You may use a chase with a vent termination with
exposed pipe on the exterior of the house. See
In-
stalling Vent System in a Chase,
page 11.