-20 -
For more information, visit www.desatech.com
9. Take twigs "D" (bent twig) and place them as shown in
figure 53.
10. Place twig "E" across the top of Logs "B" in the remaining
notches as shown in figure 53.
11. When finished installing the logs, close the glass doors
while making certain that all four latches are securely
fastened.
12. Replace the louvers in reverse order with the grilles
pointing in the down position.
GLASS DOOR CLEANING AND REPLACEMENT
When cleaning or replacement becomes necessary, refer to the
following steps.
NOTE: Before proceeding make sure unit is completely cool.
1. Remove the top and bottom louvers and the screen
assembly (Refer to figure 38). Undo the four door latches
(Refer to figure 49). The procedure for removing the end
louver panel is the same. However, the entire frame must be
removed as one assembly.
REPLACING THE GLASS DOOR
2. If replacement of the glass is necessary, the entire assembly
(frame and glass) must be replaced. If glass is broken you may
want to wear gloves and tape the remaining fragments onto the
frame. Remove the five (5) screws located on the end of the
firebox while holding frame assembly to prevent it from
falling and causing injury. Remount the new frame at the
hinge with five (5) new screws, before closing and latching the
door. This will ensure seating of the gasket. If replacing the
end glass panel, you must remove the (16) sixteen screws
around the frame (see figure 54. To insure proper fit, when
installing the new glass panels, make certain that the seam in
the gasket is placed in the down position.
3. To install or replace items removed, simply reverse the
procedures in step one.
Figure 49 SPRING LATCHES
LEFT
RIGHT
BA
CK
FR
ONT
Figure 50 BURNER AND GRATE (TOP VIEW)
FRO
N
T
LEFT
RIGHT
BACK
Figure 51 INSTALLING LOGS “A” (TOP VIEW)
FRONT
LEFT
RIGHT
BACK
Figure 52 INSTALLING LOGS “B” (TOP VIEW)
FRO
N
T
LEFT
RIGHT
BAC
K
Figure 53
INSTALLING TWIGS “C,D,E” (TOP VIEW)