![background image](http://html1.mh-extra.com/html/desa/v-cd36t-n/v-cd36t-n_owners-operation-and-installation-manual_2486219030.webp)
www.desatech.com
116035-01J
30
FIREPLACE INSTALLATION
Continued
pRESSURE TESTING FIREpLACE GAS
CONNECTIONS
1. Open equipment shutoff valve (see Figure
53, page 29).
2. Open propane/LP supply tank valve for
propane/LP fireplace or main gas valve
located on or near gas meter for natural
gas fireplace.
3. Make sure control knob of fireplace is in
the OFF position.
4. Check all joints from equipment shutoff
valve to gas valve (see Figure 54 or Figure
55 on page 29). Apply noncorrosive leak
detection fluid to all joints. Bubbles form
-
ing show a leak. Retighten all fittings
5. If leaks still exist, turn off gas supply and
call a qualified service person.
6. Light fireplace (see
Operation
, page 32).
Check all other internal joints for leaks.
7. Turn off fireplace (see
To Turn Off Gas to
Appliance
, page 33 or 36 depending on
model).
REMOvING/REPLACING GLASS
DOOR
CAUTION: Do not operate
this fireplace with a broken glass
door panel or without the glass
door panel securely in place. For
replacement part information see
Replacement Parts
, page 45.
CAUTION: Wear gloves and
safety glasses while handling or
removing broken glass. Do not re
-
move if glass is hot. Keep children
and pets away from glass.
WARNING: If fireplace has
been running, turn off and un
-
plug fireplace. Let cool before re
-
moving glass door or louvers.
Removing Lower Louver Access Panel
1. Grasp lower louver panel and pull up until
hanger brackets release from door pins
(see Figure 56).
2. Swing louver panel out until it clears fire
-
place opening.
Figure 56 - Removing Lower Louver
Access Panel
Door Pin
Hanger Bracket
Lower Louver
Access Panel
3. Pull entire panel out until bottom tabs are
free of slot openings in lower face frame.
Figure 57 - Removing Top Louver Trim
Panel
Panel Tabs
Top Louver
Trim Panel
Door Pin
Hanger
Bracket
Removing Top Louver Trim Panel
1. Grasp two hanger brackets at bottom and
pull up until hanger brackets release from
door pins (see Figure 57).
2. Swing out bracket ends until upper panel
tabs can be angled out of slot openings
in upper face frame.
3. Pull entire louver trim panel out of face
frame.