105536
3
3
For more information, visit www.desatech.com
For more information, visit www.desatech.com
PRODUCT IDENTIFICATION
Figure 1 - 40 Model
Figure 2 - 55T/70T Models
Handle
Fuel
Cap
Lower
Shell
Power Cord
Fuel Tank
Hot Air
Outlet
Air Filter
End Cover
Fan Guard
Upper Shell
Side Cover
Ignition Control
Assembly
(assembly on inside
of side cover)
Thermostat
Knob
Nose Cone Guard
Side Cover
Fuel
Tank
Lower
Shell
Hot Air
Outlet
Nose Cone Guard
Handle
Upper Shell
Power Cord
Fuel
Cap
Air Filter
End
Cover
Fan Guard
Ignition Control
Assembly
(assembly on inside
of side cover)
Figure 3 - 115T/165T Models
Lower
Shell
Hot Air
Outlet
Fan Guard
Fuel
Tank
Side Cover
Fuel Cap
Upper Shell
Power Cord
Ignition Control
Assembly (assembly on
inside of side cover)
Thermostat
Knob
UNPACKING
1.
Remove all protective packaging that has been applied to heater
for shipment
2.
Remove heater from carton.
3.
Check heater for any shipping damage. If damage is found,
promptly inform dealer where heater was purchased.
ASSEMBLY
(FOR 40, 55T, AND 70T MODELS ONLY)
These models are furnished with a nose cone guard. Nose cone
guard and mounting screws are found in the shipping carton.
Tools Needed
• 5/16" Nut Driver or Wrench
1.
Place nose cone guard on top of upper shell flange. Make sure
nose cone guard is on hot air outlet end of heater.
2.
Insert screws through nose cone guard and upper shell flange.
3.
Tighten screws firmly.
Figure 4 - Nose Cone Guard Assembly, 40/55T/70T Models Only
Nose Cone
Guard
Screw
Hot Air
Outlet
Upper
Shell
Flange
PRODUCT IDENTIFICATION
UNPACKING
ASSEMBLY
