www.ironhaus.com or www.desatech.com
121333-01A
25
Installing 9-Volt Alkaline Battery in Hand-
Held Remote Control Unit
1. Remove battery cover on back of remote
control unit.
2. Attach terminal wires to a 9-volt alkaline
battery (not included). Place battery into
battery housing.
3. Replace battery cover onto remote control
unit.
FIRePLACe INSTALLATIoN
Continued
Figure 40 - Installing Battery in Hand-
Held Remote Control Unit
9-Volt Battery
Battery
Housing
Battery Cover
Terminal
Wires
Remote Control Unit
REMOVING/REPLACING GLASS
DOORS
CAUTION: Do not operate
this fireplace with a broken glass
door panel or without the glass
door panel securely in place.
For replacement part informa
-
tion see
Replacement Parts
,
page 37.
CAUTION: Wear gloves and
safety glasses while handling
or removing broken glass. Do
not remove if glass is hot. Keep
children and pets away from
glass.
WARNING: If fireplace has
been running, turn off and un
-
plug fireplace. Let cool before
removing inner glass door or
louvers.
Removing Louver Panels
Remove top and bottom louver panels by
simultaneously pulling both top end spring
latches towards center of appliance until
they are disengaged from locating holes
(see Figure 42). Repeat for bottom spring
latches and pull louvers outward. To install
or replace items removed, simply reverse
procedures above.
Figure 42 - Removing Louver Panel
Louver
Panel
Spring
Latch
Pin
Door
Enclosure
Frame
Slot for
Pin
Outer Door Installation
It is important that you remove glass doors
prior to installing your fireplace. To remove
doors, pull up and out to disengage pins.
Set doors aside until installation of fireplace
is complete. Reinstall doors by seating pin
on door into slot on enclosure frame (see
Figure 41).
Figure 41 - Installing Glass Doors
