www.desatech.com
123167-01D
20
OPERATION
Continued
Figure 25 - Pilot
Ignitor Electrode
Pilot
Burner
Thermocouple
CAUTION: Do not try to ad-
just heating levels by using the
equipment shutoff valve.
If Using Optional Remote Control
10. Wait one minute and switch selector switch
to the ON position to light burners (see
Figure 26).
Note: AUTO is only functional when
using HRC100 or HRC200 optional
accessories.
11. Set control knob to HI or LO.
12. To leave pilot lit and shut off burners only
either turn control knob clockwise
to the PILOT position or use remote con-
trol manual OFF button.
WARNING: Make sure the se-
lector switch is in the OFF position
when you are away from home for
long periods of time. Heater will
come on automatically with selec-
tor switch in the ON position.
TO TURN OFF GAS
TO AppLIANCE
1. Turn control knob clockwise
to OFF
position.
2. Close equipment shutoff valve (see Figure
14, page 15).
ON
OFF
REMOTE
PILOT
OFF
LO
HI
Figure 26 - Setting Selector Switch and
Control Knob for Remote Operation
MANUAL LIGHTING
pROCEDURE
1. Follow steps 1 through 5 under
Lighting
Instructions
beginning on page 19.
2. Press control knob and light pilot with
match.
3. Keep control knob pressed in for 30 sec
-
onds after lighting pilot. After 30 seconds,
release control knob. Now follow step 8
under
Lighting Instructions,
page 19.
OpTIONAL HAND-HELD
REMOTE OpERATION
Note: All remote control accessories must
be purchased separately (see Accessories,
page 28). Follow instructions included with
the remote control.
NOTICE: You must light the pilot
before using the hand-held re
-
mote control unit. See
Lighting
Instructions
on page 19.
After lighting, let pilot flame burn for about
one minute. Turn control knob to HI or LO.
Slide selector switch to REMOTE position
(see Figure 26).
Note: Burner may light if hand-held remote
was on when selector switch was last turned
off. You can now turn burner on and off with
hand-held remote control unit.
IMPORTANT:
Do not leave selector switch in
REMOTE or ON position when pilot is not lit.
This will drain battery.
ON/OFF SERIES (MODEL HRC100)
Hold control button on hand-held remote until
burner turns on. Hold control button again until
burner turns off (see Figure 27).
Figure 27 - On/Off Hand-Held Remote
Control Unit
Control
Button
Indicator
Light
