![background image](http://html.mh-extra.com/html/desa/hd18nra/hd18nra_owners-operation-and-installation-manual_2485900017.webp)
www.desatech.com
123167-01D
17
MILLIVOLT VALVE BATTERY pACK
Battery Installation
Batteries must be installed before millivolt
valve will operate.
1. Locate battery pack on left side of unit
(see Figure 20).
2. Install 2 D-cell batteries (not included)
into battery housing as shown in Figure
20. Pay close attention to positive (+)
and negative (-) markings on battery
housing.
INSTALLATION
Continued
Figure 19 - Installing Battery in Hand-Held
Remote Control Unit
9-Volt Battery
Battery
Housing
Battery Cover
Terminal
Wires
Remote Control Unit
Figure 20 - Installing Millivolt Valve
Battery Pack Batteries
INSTALLING LOGS
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
CAUTION: After installa-
tion and periodically thereafter,
check to ensure that no flame
comes in contact with any log.
With the heater set to High, check
to see if flames contact any log. If
so, reposition logs according to
the log installation instructions
in this manual. Flames contact
-
ing logs will create soot.
It is very important to install these logs exactly
as instructed. Do not modify logs. Only use
logs supplied with heater.
1. Place rear log (#1) onto base. Holes in
bottom of log must seat over pins on base
as shown in Figure 21.
2. Place middle log (#2) onto base. Holes in
bottom of log must seat over pins on base
as shown in Figure 21.
Positive
D Batteries
Battery
Pack
Left Side of
Unit
Figure 21 - Installing Rear and Middle Logs
Burner
Middle Log
Rear Log
Pin for
Hole in
Bottom
of Log
Battery Replacement
1. Shut unit off by turning control knob to the
OFF position.
2. Make sure unit has been off for at least 5
minutes.
3. Press switch to the OFF position.
4. Replace with new batteries and wait 5
seconds, then press switch to the ON
position.
5. Follow lighting instructions on page 19 to
turn unit back on.